KemTab Aqua

pictures

description

KEMPER KemTab Aqua water cutting beds are suitable for Plasma cutting of sheet metal above as well as under water. Besides the considerable noise reduction and the absorption of cutting dust, the material has very low distortion levels. For cutting above or under water it is essential to have a table with a variable water level.

Integrated air chambers
The KEMPER Water cutting bed with level control is equipped with air chambers by which the water level can be varied.
By feeding or draining air in or out of the integrated air chambers it is possible to change the water level of the unit.

The slag generated while cutting is collected in slag boxes underneath the material supports. These can easily be lifted out and cleaned after the material supports have been taken away and the water level has been reduced.

Water cutting unit with hydraulic level control
As opposed to the above mentioned unit, the KEMPER water cutting bed has no fixed material supports but rather an adjustable support. This way it is possible to cut material above as well as under water.

Advantages:
• Marginal deformation of the cut material
• High quality of cutting
• Nearly no burr accumulation at the plate underside
• The water absorbs the cutting dust
• Minimal noise exposure
• automatic slag discharge

Controls
The Water cutting bed has its own operating controls. This can either be operated manually or be connected to the control of the cutting unit. Consequently a simple and automatic operation is guaranteed.

KemTab Aqua Clean with automatic discharge
KEMPER water cutting beds with automatic discharge are equipped with a rake conveyer system to discharge slag and small cut out pieces. They are discharged out of the water
cutting bed during the cutting process and collected in an adjacent container.